Choose the type of pressure valve in accordance with your ability to purchase gas cylinders. If you have a local supplier of S30 gas, then choose these, if not, and you have to buy “Sparklets” type 8gm bulbs, then choose the pin valve type.
Choose the type of pressure valve in accordance with your ability to purchase gas cylinders. If you have a local supplier of S30 gas, then choose these, if not, and you have to buy “Sparklets” type 8gm bulbs, then choose the pin valve type.Forty pint capacity barrel with a good sized neck which makes it easier to clean and re-use. A pressure valve is included with the barrel.. Height 46cm, width 35cm. Beer capacity 40 pints.
The new S30 valve for your keg comes in high grade stainless steel.
The S30 valve can be equipped with a small piercing pin if you want to use 8g CO2 bulbs (use the bulb holder below to screw these onto the valve). You can insert and remove the pin and easily switch between using S30 cylinders and 8g bulbs.
For convenience, the valve comes in two versions – either pre-equipped with a piercing pin for 8g bulbs, or plain for use with S30 cylinders. Whichever version you get, it is as simple as removing/inserting the pin to change version.
When you remove or insert the pin, you need to temporarily remove the small o-ring inside first (use a knife or small screwdriver – carefully).
• 19 L (5 US Gal) capacity.
• Embossed Logo.
• Rubber top and bottom for east transportation and stacking.
• NSF Approved for food and beverage consumption.
• Stainless steel body.
• Compatible with cornelius parts.
The S30 conversion pack contains a high grade stainless steel pin for use with 8g CO2 bulbs, plus a small o-ring to fit inside the S30 valve. For conversion of an S30 valve, simply put the pin in and you have a 8g bulb version of the valve (use the S30 bulb holder for injecting the 8g bulbs).
The S30 valve always contains a small o-ring inside. The one in the conversion pack is there only in case you damage the original one when you change over and put the pin in. For inserting or removing the 8g pin, you need to first temporarily remove the small o-ring. That is best done with a small knife or a very small screwdriver.